Configuring the Ports

1. Navigate to Switch -> Port -> Config.

2. Select multiple ports as appropriate by using "<Shift> Click" and "<Ctrl> Click".

3. All ports with connections to VME Controllers should be configured as follows:

   STP Mode	Disable
   Admin Mode	Enable
   LACP Mode	Disable
   Physical Mode	1000 Mps Full Duplex
   Link Trap	Disable
   Maximum Frame Size	10240

    

4. Note: The physical mode of ports connected to the VME Controllers can be set to "Auto Negotiate". Previously this was not the case.

5. Click "Submit".

6. Go back to step 2 and repeat as needed for other ports.